PTO Applications
PTO Shafts for :

John Deere Round Balers

Models: 447, 449, 457, 458 Standard, 458, 458 Silage Special, 459, 467, 468, 469, 547, 557, 558, 559, 567, 568, 569

John Deere calls for CAT4 and CAT5 constant velocity drivelines depending on model, with friction clutch.

Original Equipment PTO Shaft will Vary

Input shafts are 1.375-6 or 1.375-21. Please call 800-824-0706 with your specifications.

MAIN SHAFT: CAT 3, 4, 5 Constant Velocity

Available for tractors using 1.375"-6 or 1.375"-21 spline.

Input shaft is usually 1.375-6.

Other combinations are available.

If you have a 1.75" x 20 spline tractor output we can modify a PTO CV head for you. Please call!

Model PTO / RPM Protection
448 CAT4/540 FRICTION CLUTCH
458 CAT3/540 SHEARBOLT
458 CAT4/540 FRICTION CLUTCH
558 CAT4/540 FRICTION CLUTCH
468 CAT4/540 FRICTION CLUTCH
468 CAT5/1000 FRICTION CLUTCH
568 CAT4/540 FRICTION CLUTCH
568 CAT5/1000 FRICTION CLUTCH

Original Equipment

OEM Weasler Half Shaft Replacements

 

Please check the telescoping spline diameter. Both sizes were used on various models.

OEM John Deere Half Shaft Replacements

Category Tractor splines Telescoping splines Part Number

Tube Profile and Recommended replacement:

Constant Velocity PTO Tractor

Base Part Number

(add implement device)

CAT3/540
1.375-6
CAT4/540
1.375-6
CAT4/1000
1.375-21
CAT5/540
1.375-6
CAT5/1000
1.375-21

 

Baler Input Requirements:

 Torque Protection

FT Clutches for 1.375-6 spline input

Universal Size Torque nm Part Number
CAT3 / S4
1000nm
CAT3 / S4
1000nm
CAT4 / S6
1800nm
CAT5 / S8
1450nm

 

BYP FT42 Friction Clutch

please excuse any errors in our model numbers and specifications research