MAIN SHAFT |
|||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
John Deere Rotary Cutters
Models: 609, 709
 3 point |
 3 point |
pull type
USING CAT4 CV DRIVELINES and JACK SHAFT FOR PULL TYPE
Original Equipment calls for CAT4 -- either Waltersheid 2400 or Bondioli and Pavesi Size 6
JACK SHAFT (see our spec sheet for Jack Shafts) |
||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Support Bearing Mount
* Support bracket will vary with year and model |
FRICTION CLUTCH |
||||||
|---|---|---|---|---|---|---|
Our research indicates input shaft is 1.375-21 spline  |
||||||
609 and 709 Mowers can be fitted with a variety of clutches. Setting should be 1450nm - 1850nm |
||||||
|
| please excuse any errors in our model numbers and specifications research | |